Can WAS 6.0.0.2 (FP2) be installed in RAD 6.0 Testenvironment ? - Websphere

This is a discussion on Can WAS 6.0.0.2 (FP2) be installed in RAD 6.0 Testenvironment ? - Websphere ; Is there a way to do this, or is it not recommended ? Bjørn-Willy...

+ Reply to Thread
Results 1 to 3 of 3

Thread: Can WAS 6.0.0.2 (FP2) be installed in RAD 6.0 Testenvironment ?

  1. Can WAS 6.0.0.2 (FP2) be installed in RAD 6.0 Testenvironment ?

    Is there a way to do this, or is it not recommended ?

    Bjørn-Willy


  2. Re: Can WAS 6.0.0.2 (FP2) be installed in RAD 6.0 Testenvironment?

    Actually, I just installed WAS FP2 into the RAD 6.0 and is runs
    perfectly, so far

    Bjørn-Willy Arntzen wrote:

    > Is there a way to do this, or is it not recommended ?
    >
    > Bjørn-Willy
    >



  3. Re: Can WAS 6.0.0.2 (FP2) be installed in RAD 6.0 Testenvironment ?

    Hi Bjørn-Willy,

    Anything that you can do to a normal WSAS install can be done to the v6 Test
    Environment as well.

    http://www.ibm.com/support/docview.wss?uid=swg21199423

    if you want additional information.

    - Troy

    "Bjørn-Willy Arntzen" wrote in message
    news:d06oq5$2jcs$1@news.boulder.ibm.com...
    > Is there a way to do this, or is it not recommended ?
    >
    > Bjørn-Willy
    >




+ Reply to Thread