Vxworks windriver work bench - VxWorks

This is a discussion on Vxworks windriver work bench - VxWorks ; Hiii All, i have many Vxworks Application file source...i m supposed to compile it , link it and build the image for the powerpc target board...all the above things should be done using the WindRiver work bench 3.1...i m new ...

+ Reply to Thread
Results 1 to 2 of 2

Thread: Vxworks windriver work bench

  1. Vxworks windriver work bench

    Hiii All,

    i have many Vxworks Application file source...i m supposed to compile it , link it and build the image for the powerpc target board...all the above things should be done using the WindRiver work bench 3.1...i m new to this tool and has got no idea about the entry point of the program and generating image..please help..

  2. Smile Re: Vxworks windriver work bench

    i din't understaned from your post what vxworks are you using and what vxworks are you going to use? also what workbeck are you using or do you use tornado?

    anyway, i can deeply advice you to not go to WB 3.1, it has a lot of bugs (and i'm talking only about the WB 3.1 and not the vxworks 6.7).
    if you can go straite to WB 3.2 (and upgrade it to WB 3.2.2).

    you better read the "getting started" manual if you are a real beginner.
    you will need to make a VIP project based on your BSP files. only after that you will create a DKM project base on your application and eventually link them together.

    good luck,
    Eli

+ Reply to Thread