Re: VxWorks as a gateway?
>I am building a circuit board with a PowerPC running VxWorks 6.3...
>The PowerPC has 2 ethernet interfaces.
>On interface 1 is the outside world.
>On interface 2 is a ethernet switch on a chip with 2 TI DSP chips
>hanging off it.
>I was planning on hardcoding the DSP chips IP addresses to
>192.168.1.101 and 102.
>I was planning on setting the PPC up as a router so we could get to
>the DSP's from the outside (telnet, debug, etc).
>I'd appreciate any feedback on... Is this practical? The best way?
>How do we configure the VxWorks to do the router/gateway function?
>What address would we use to access the DSPs from the outside?[/color]
I don't have any 6.x experience, but in version 5.x one does this sort
of thing using API's in the routeLib library as described in section
4.7.1 of the Network Programmer's Guide.
Michael Kesti | "And like, one and one don't make
| two, one and one make one."
mrkesti at hotmail dot com | - The Who, Bargain