I'm having a problem with my DQ130/pertec tape setup on my 11/23plus.
When I try to initialize a new tape on it, it spins back and forth for a
bit, then the alert light comes on. I think it has something to do with
the DQ130 card - The card supposedly emulates TM11, so I *think* that's
800BPI only, but the tape drive only supports 1600/3200BPI(at least,
according to the front panel) I know there's nothing wrong with the
tape drive, as I tested it with its parallel connection and was able to
read/write tapes just fine.



Do I need a DQ132 or better card to make this work?