Here is an example of a volume I am trying to mimic on another system:
v arch_rep - ENABLED ACTIVE 426748160 fsgen -
ROUND
pl arch_rep-01 arch_rep ENABLED ACTIVE 426751881 STRIPE 4/128
RW
sd disk23-01 arch_rep-01 disk23 0 71124291 0/0 c5t0d0
ENA
sd disk24-01 arch_rep-01 disk24 0 35563590 0/71124291 c5t1d0
ENA
sd disk29-01 arch_rep-01 disk29 0 71124291 1/0 c10t0d0
ENA
sd disk30-01 arch_rep-01 disk30 0 35563590 1/71124291 c10t1d0
ENA
sd disk35-01 arch_rep-01 disk35 0 71124291 2/0 c11t8d0
ENA
sd disk36-01 arch_rep-01 disk36 0 35563590 2/71124291 c11t9d0
ENA
sd disk43-01 arch_rep-01 disk43 0 71124291 3/0 c12t10d0
ENA
sd disk42-01 arch_rep-01 disk42 0 35563590 3/71124291 c12t9d0
ENA

The stripe has 4 columns each going to a different controller. I am unable
to replicate this to another system using the command line. The ncols attribute
doesnt seem to be working or I am doing something wrong. (this is vxvm 4.0)

The system I am trying to duplicate this on is almost identical except I
only want 2 columns instead of 4. (thus using 2 controllers)

Anyone know the command line method of doing this?

Thx,
CC