Does the sgscan driver see the robot ?
../volmgr/bin/sgscan
if not check that the sgscan driver run
../modinfo grep |sg (if I remember correctly )
here is the recommended firmware level : StorEdge L9 TLD 2.06


Finally :the device configuration guide provides further details about the
configuration


"Jane Ilin" wrote in message
news:3c0663c6@hronntp01....
>
> I am running Solaris 8 on SunFire 280R and I have Sun StorEdge L9 robot (
> one tape drive ).
> NetBackup can see my robot as DLT standalone tape drive only and not as a
> robot.

I am running the same configuration just fine. Did you correctly
set the SCSI IDs? You'll find in the L9 installation manual that
you need to set 2 SCSI IDs. 1 for the autoloader controller and
1 for the DLT drive. Also, run the command:
/usr/openv/volmgr/bin/sgscan -v and you should see output like

/dev/sg/c0t4l0: Tape (/dev/rmt/2): "QUANTUM DLT8000 0114"

Hope this helps.