STK L700 robot - Veritas Net Backup

This is a discussion on STK L700 robot - Veritas Net Backup ; I'm having trouble getting a STK L700 robot to inventory. I can move it around and get it to move tapes with robtest, but when I try to get an inventory through xvmadm it always fails with Process Killed by ...

+ Reply to Thread
Results 1 to 2 of 2

Thread: STK L700 robot

  1. STK L700 robot


    I'm having trouble getting a STK L700 robot to inventory. I can
    move it around and get it to move tapes with robtest, but when
    I try to get an inventory through xvmadm it always fails with
    Process Killed by Signal (211)

    sol2.6, patchset 4.0.10, netbackup3.2ga, j080326. Using JNI
    fcaw 64bit Sbus with 2.2.4.EMC driver, through crossroads bridge
    to L700. Also tried SCSI FWD direct connect with same results.

    Anyone else seen this error? Got any suggestions?



  2. Re: STK L700 robot


    "David Czech" wrote:
    >
    >I'm having trouble getting a STK L700 robot to inventory. I can
    >move it around and get it to move tapes with robtest, but when
    > I try to get an inventory through xvmadm it always fails with
    >Process Killed by Signal (211)
    >
    >sol2.6, patchset 4.0.10, netbackup3.2ga, j080326. Using JNI
    >fcaw 64bit Sbus with 2.2.4.EMC driver, through crossroads bridge
    >to L700. Also tried SCSI FWD direct connect with same results.
    >
    >Anyone else seen this error? Got any suggestions?
    >
    >

    Hi David,

    You probably need the latest jumbo patch (at this time, it ends
    in "363") from Veritas. After having initialized the L700 and
    having installed the patch, my Volume Manager queried the
    robot and built its database from what it found. This assumes
    you have set up the tape recognition rules in VM, the robot is
    connected properly, and a bunch of other prerequisites.

+ Reply to Thread