BE9 (4454) and duplicate job problem - Veritas Backup Exec

This is a discussion on BE9 (4454) and duplicate job problem - Veritas Backup Exec ; I have just recently updated to BackupExec 9 4454 and I am now having an error with my duplicate job. I have a main job that performs a backup from network locations to a partitioned set of tapes. Then I ...

+ Reply to Thread
Results 1 to 2 of 2

Thread: BE9 (4454) and duplicate job problem

  1. BE9 (4454) and duplicate job problem


    I have just recently updated to BackupExec 9 4454 and I am now having an error
    with my duplicate job. I have a main job that performs a backup from network
    locations to a partitioned set of tapes. Then I have a job performing after
    the main job that performs a duplicate job to a different set of partitioned
    tapes.

    This duplicate job was working properly until the 4454 upgrade. The job never
    starts after the main job has ended, and if you try to force the duplicate
    job, a "script error" occurs.

  2. Re: BE9 (4454) and duplicate job problem


    Moin Lou,
    according to "Administrator' s Guide 9.0" page 300 a duplicated job can go
    only to a different tape. A "different partition" is the same tape.
    You may be use "BackUpToDisk" as a different "tape".
    Hope that help
    Rainer

    "Lou Paris" wrote:
    >
    >I have just recently updated to BackupExec 9 4454 and I am now having an

    error
    >with my duplicate job. I have a main job that performs a backup from network
    >locations to a partitioned set of tapes. Then I have a job performing after
    >the main job that performs a duplicate job to a different set of partitioned
    >tapes.
    >
    >This duplicate job was working properly until the 4454 upgrade. The job

    never
    >starts after the main job has ended, and if you try to force the duplicate
    >job, a "script error" occurs.



+ Reply to Thread