Jobs start on hold - Veritas Backup Exec

This is a discussion on Jobs start on hold - Veritas Backup Exec ; I just downloaded and installed the newest version of 9.0 and am trying to create a test job to get familiar with this product. The problem I'm having is after creating a new policy and a new job, the job ...

+ Reply to Thread
Results 1 to 3 of 3

Thread: Jobs start on hold

  1. Jobs start on hold


    I just downloaded and installed the newest version of 9.0 and am trying to
    create a test job to get familiar with this product. The problem I'm having
    is after creating a new policy and a new job, the job starts to run then
    shows the status 'Hold'. I have a tape in the drive and didn't create the
    job to start on hold, so why is it going to hold status.

    NW5.1 SP3

    TAI,
    Chris

  2. Re: Jobs start on hold


    I didn't see the Job Log before...it looks like the jobs start to run, then
    I get an error: A read error occurred on the media-24609.

    Any suggestions?

    "Chris" wrote:
    >
    >I just downloaded and installed the newest version of 9.0 and am trying

    to
    >create a test job to get familiar with this product. The problem I'm having
    >is after creating a new policy and a new job, the job starts to run then
    >shows the status 'Hold'. I have a tape in the drive and didn't create the
    >job to start on hold, so why is it going to hold status.
    >
    >NW5.1 SP3
    >
    >TAI,
    >Chris



  3. Re: Jobs start on hold


    I'm getting the same error (24609) using BENW 9.0 and NetWare 5.0 SP6a and
    an Adaptec 160 in a Compaq ML350 and Compaq 12/24 DDS3 drive. If you find
    a resolution, please let me know!


    "Chris" wrote:
    >
    >I didn't see the Job Log before...it looks like the jobs start to run, then
    >I get an error: A read error occurred on the media-24609.
    >
    >Any suggestions?
    >
    >"Chris" wrote:
    >>
    >>I just downloaded and installed the newest version of 9.0 and am trying

    >to
    >>create a test job to get familiar with this product. The problem I'm having
    >>is after creating a new policy and a new job, the job starts to run then
    >>shows the status 'Hold'. I have a tape in the drive and didn't create the
    >>job to start on hold, so why is it going to hold status.
    >>
    >>NW5.1 SP3
    >>
    >>TAI,
    >>Chris

    >



+ Reply to Thread