I am trying to boot an Ultra 5 from an external Fibre Channel disk
array (a T3), without success.

The Ultra 5 has a Qlogic 2202F installed flashed with prom 2.00.05

Here is what i get with probe-scsi-all:

ok probe-scsi-all
/pci@1f,0/pci@1/pci@2/QLGC,qla@5
QLA2200 Fibre Channel Host Adapter fcode version 2.00.05 02/03/03
Firmware version 2.02.03
Error: Timed-out waiting for the firmware Ready state
Possible causes: No cable, incorrect connection mode, incorrect data
rate

/pci@1f,0/pci@1/pci@2/QLGC,qla@4
*************************** Local Loop Devices
***************************
Adapter loopId - 0
Device AL-PA e2 loopId 3 Hard-addr 0 Port WWN
50020f2300006d0f
Lun 0 DISK SUN T300 0118
Lun 1 DISK SUN T300 0118


ok

I have tried a Solaris 10 fresh install on slice 0 of LUN 1. The
installer set the boot-device as:

/pci@1f,0/pci@1/pci@2/QLGC,qla@4/fp@0,0/ssd@w50020f2300006d0f,1:a

but when booting I get:


Rebooting with command: boot /pci@1f,0/pci@1/pci@2/QLGC,qla@4/fp@0,0/
ssd@w50020f2300006d0f,1:a
Boot device: /pci@1f,0/pci@1/pci@2/QLGC,qla@4/fp@0,0/
ssd@w50020f2300006d0f,1:a File and args:
QLA2200 Fibre Channel Host Adapter fcode version 2.00.05 02/03/03
Firmware version 2.02.03

Evaluating: boot /pci@1f,0/pci@1/pci@2/QLGC,qla@4/fp@0,0/
ssd@w50020f2300006d0f,1:a

Can't open boot device



show-disks gives:

ok show-disks
a) /pci@1f,0/pci@1/pci@2/QLGC,qla@5/sd
b) /pci@1f,0/pci@1/pci@2/QLGC,qla@4/sd
c) /pci@1f,0/pci@1,1/ide@3/cdrom
d) /pci@1f,0/pci@1,1/ide@3/disk
e) /pci@1f,0/pci@1,1/ebus@1/fdthree@14,3023f0
q) NO SELECTION
Enter Selection, q to quit:

So I tried too booting with

/pci@1f,0/pci@1/pci@2/QLGC,qla@4/sd@3,1:a

and

/pci@1f,0/pci@1/pci@2/QLGC,qla@4/fp@3,1:a

With similar results.

I do not know what else to try. Anyone could help with clues?

Thank you in advance,
HD