missing PCI BAR on bootup for pciba, Help Bruce Johnson or any one?
Well, its 4 o'clock on a saturday and workaday stuff is bugging
using Irix 6.5.11m on an Origin 200.
trying to user level I/O via 'pciba' on a PCI card that uses Only
BAR0 and Bar2. after locating the card via /hw/.id/pci/'etc'...,
only the /hw graph is created for BAR 0. And I need to
mmap via Bar 2, where all the action is for this card.
Using the old faithful 'cardinfo.c' (from Bruce Johnson?) only
BAR 0 is shown. cardinfo.c steps thru the BARs 0-N until
a BAR returns zero. But if i modify cardinfo.c to step thru
and print BAR0 thru BAR5, I get an addy for BAR0, zero
for BAR1, and an addy for BAR2, and an zero from BAR3
on an Origin 200 with 6.5.11m, does the bootup stop probing
and adding to the /hw graph after one of the BARs (0 thru N)
My customer on a 3000 with a later rev of irix gets BAR2
in the /hw graph on bootup for the same pci card.
Is it my Origin 200 hardware or my primitive OS level that doesn't find this
BAR2 on bootup?
BAR0: sensible addy
BAR2: sensible addy
No BAR2 after bootup available thru /hw graph for mmap.
any replies On or Close to topic are invited.
time is of the essence, aint it always?