tun0: Warning: ff02::%tun0/32: Change route failed: errno: Undefined error: 0 - PPP

This is a discussion on tun0: Warning: ff02::%tun0/32: Change route failed: errno: Undefined error: 0 - PPP ; Hi, i am using ppp with openbsd and i am not able to get rid of this error message: tun0: Warning: ff02::%tun0/32: Change route failed: errno: Undefined error: 0 I get this warning everytime I connect or disconnect my ppp ...

+ Reply to Thread
Results 1 to 2 of 2

Thread: tun0: Warning: ff02::%tun0/32: Change route failed: errno: Undefined error: 0

  1. tun0: Warning: ff02::%tun0/32: Change route failed: errno: Undefined error: 0

    Hi,

    i am using ppp with openbsd and i am not able to get rid of this error
    message:

    tun0: Warning: ff02::%tun0/32: Change route failed: errno: Undefined error:
    0

    I get this warning everytime I connect or disconnect my ppp connection but
    my connection works flawlessly.

    Here is my ppp.conf:

    default:
    set log Phase Chat IPCP CCP tun command
    set redial 15 0
    set reconnect 15 10000
    pppoe:
    set device "!/usr/sbin/pppoe -i xl1"
    set mtu max 1454
    disable acfcomp protocomp ipv6cp
    deny acfcomp
    set crtscts off
    set speed sync
    enable lqr
    set lqrperiod 60
    set dial
    set login
    set timeout 0
    set authname "XXX"
    set authkey "XXX"
    enable dns
    enable mssfixup
    add! default HISADDR

    any idea?




  2. Re: tun0: Warning: ff02::%tun0/32: Change route failed: errno: Undefined error: 0

    "Till Boehmert" writes:

    ]Hi,

    ]i am using ppp with openbsd and i am not able to get rid of this error
    ]message:

    ]tun0: Warning: ff02::%tun0/32: Change route failed: errno: Undefined error:
    ]0

    Sounds like a routing error, not a ppp error. May be an attempt to
    redefine the default route?

    Maybe from the
    add! default HISADDR
    line



    ]I get this warning everytime I connect or disconnect my ppp connection but
    ]my connection works flawlessly.

    ]Here is my ppp.conf:

    ]default:
    ]set log Phase Chat IPCP CCP tun command
    ]set redial 15 0
    ]set reconnect 15 10000
    ]pppoe:
    ]set device "!/usr/sbin/pppoe -i xl1"
    ]set mtu max 1454
    ]disable acfcomp protocomp ipv6cp
    ]deny acfcomp
    ]set crtscts off
    ]set speed sync
    ]enable lqr
    ]set lqrperiod 60
    ]set dial
    ]set login
    ]set timeout 0
    ]set authname "XXX"
    ]set authkey "XXX"
    ]enable dns
    ]enable mssfixup
    ]add! default HISADDR

    ]any idea?




+ Reply to Thread