Hi all.

On my girlfriend's laptop, she's running linux-2.4.26 with pcmcia-cs
3.2.8 (cardbus controller TI PCI1130, doesn't work with 2.6 yenta).

I have successfully used a cardbus USB-controller with dummy_cb, but
can't get a new USR 5410 (TI ACX111) card to run. dummy_cb loads (two
high beeps), but subsequent tries to load a driver for it (Linuxant
DriverLoader and ndiswrapper) fails to recognise the card (pcilib:
Cannot open /proc/bus/pci/05/00.0).

The card is identified to cardmgr as PCI ID 0x104c, 0x9066.

lspci shows:

pcilib: Cannot open /proc/bus/pci/05/00.0
Unable to read 64 bytes of configuration space.00:00.0 Host bridge:
PicoPower Technology PT86C521 [Vesuvius v1] Host Bridge (rev 04)
00:06.0 ISA bridge: PicoPower Technology PT86C523 [Vesuvius v3] PCI-ISA
Bridge Slave
00:07.0 VGA compatible controller: Neomagic Corporation NM2090
[MagicGraph 128V] (rev 01)
00:08.0 IDE interface: CMD Technology Inc PCI0643
00:09.0 CardBus bridge: Texas Instruments PCI1130 (rev 04)
00:09.1 CardBus bridge: Texas Instruments PCI1130 (rev 04)

What can I do?

With my best regards,

Sune Mølgaard