Hi,

I am working on a PDA based board which has a NEC MIPS VR4131
processor.
The board has a companion chip MediaQ 1132 which has OHCI support
builtin.
The kernel used is MontaVista HardHat 2.4.18. I am trying to configure
MQ1132 for USB Host support. It looks like the Host controller
(MQ1132) is initialized properly but not sure. When I plug in a USB
stick on to the USB port, I get the following messages.
-----------------------------------------------------------------
hub.c: USB new device connect on bus1/1, assigned device number 2
usb-ohci.c: unlink URB timeout
usb.c: USB device not accepting new address=2 (error=-145)

hub.c: USB new device connect on bus1/1, assigned device number 3
usb_control/bulk_msg: timeout
usb-ohci.c: unlink URB timeout
usb.c: USB device not accepting new address=3 (error=-145)
-------------------------------------------------------------------
Has anyone experienced the same out there. Could any one suggest how
to debug this error. What could be the problem?.

Thanks in advance.

Regards,
aks