Hi folks,

i want to setup a single host to host tunnel, to emulate an additional
ethernet connection.
But i'm not sure, what to use? My setup is the following:

Connection from HOST A:
{
VMWareGuest==virtualVMWareSwitch1=tunneldev=eth0
|=virtualVMWareSwitch2========|
}

to HOST B with same setup.

The goal is, to give VMware two different Networks on one physical
adapter without to let
the physics know about the additional IP (which is a different
subnet). The reason is,
the network would block a port, if different subnets are visible.

Any ideas?

Thx,

Dirk.