pse help:Simple Windows routing config - Network

This is a discussion on pse help:Simple Windows routing config - Network ; Hello, I want to set up a very simple routing lab PC1: NIC 1: 192.168.1.10 / 255.255.255 / gateway 192.168.1.1 | | | SERVEUR: NIC 1: 192.168.1.1 / 255.255.255 NIC 2: 192.168.2.1 / 255.255.255 | | | PC2: NIC 1: ...

+ Reply to Thread
Results 1 to 2 of 2

Thread: pse help:Simple Windows routing config

  1. pse help:Simple Windows routing config

    Hello,

    I want to set up a very simple routing lab

    PC1: NIC 1: 192.168.1.10 / 255.255.255 / gateway 192.168.1.1
    |
    |
    |
    SERVEUR: NIC 1: 192.168.1.1 / 255.255.255
    NIC 2: 192.168.2.1 / 255.255.255
    |
    |
    |
    PC2: NIC 1: 192.168.2.10 / 255.255.255 / gateway 192.168.2.1

    PC1 must be able to ping PC2

    So the routeur should pass the packet trough the 2 nics

    What I have o type on SERVEUR to make that possible ?

    I spent many hours with no success ;>((

    I know it is possible to activate the routing in the registry, but I
    want to do it manually

    Best regards,

    Branlebāt



  2. Re: pse help:Simple Windows routing config

    If you enable IP routing on the server, it should create the routing table
    for you.

    Routing how toHow to disable ip routing/forwarding on a W2K Pro? ... For
    example, the Generic Routing Encapsulation (GRE) IP protocol (protocol
    number 47) is added to the ...
    www.howtonetworking.com/Networking/routing.htm


    --
    Bob Lin, MS-MVP, MCSE & CNE
    Networking, Internet, Routing, VPN Troubleshooting on
    http://www.ChicagoTech.net
    How to Setup Windows, Network, VPN & Remote Access on
    http://www.HowToNetworking.com


    "Branlebāt" wrote in message
    news:mn.559f7d8107a1e0bd.85606@toi.zam...
    > Hello,
    >
    > I want to set up a very simple routing lab
    >
    > PC1: NIC 1: 192.168.1.10 / 255.255.255 / gateway 192.168.1.1
    > |
    > |
    > |
    > SERVEUR: NIC 1: 192.168.1.1 / 255.255.255
    > NIC 2: 192.168.2.1 / 255.255.255
    > |
    > |
    > |
    > PC2: NIC 1: 192.168.2.10 / 255.255.255 / gateway 192.168.2.1
    >
    > PC1 must be able to ping PC2
    >
    > So the routeur should pass the packet trough the 2 nics
    >
    > What I have o type on SERVEUR to make that possible ?
    >
    > I spent many hours with no success ;>((
    >
    > I know it is possible to activate the routing in the registry, but I want
    > to do it manually
    >
    > Best regards,
    >
    > Branlebāt
    >
    >



+ Reply to Thread