Pertains to SuSE 10.2 Linux

Hi people. So far I have been able to use my Promise TX4 raid card in
suse. This card uses the 20270 chip. After the desastrous 10.1 that
funny enough did recognize the card correctly I recently switched to
10.2

10.2 identifies the TX4 as the TX2 and as a result I lost halve my
disks on the TX4 controller due to dma and interrupt conflicts. NO
boot parameter solves this ( (no)dma, apci(on,off,force), noapic,
irqpoll routeirq etc). Anyone have suggestions?

Regards,
Robert A. Reissaus