M. Warner Losh wrote:
> In message: <49131109.2020601@FreeBSD.org>
> Alexander Motin writes:
> : Lars Engels wrote:
> : > 1. How can I tune the PCI configuration? With pciconf -w or so?
> :
> : Yes. `pciconf -r -b device addr` to read and `pciconf -w -b device addr
> : value` to write.
>
> I have changes that almost make my TI card do it.
>
> : > 2. Unfortunately the sysctl did not change a thing with regard to the
> : > Card reader.
> :
> : Have you added it to the loader.conf and rebooted?
> :
> : > 3. I added the chip ID and the second device is now recognized as a
> : > sdhci device but still does not see any card inserted:
> : >
> : > Nov 6 16:32:20 NB0117232 kernel: sdhci1: Hardware doesn't specify base
> : > clock frequency.
> : > Nov 6 16:32:20 NB0117232 kernel: sdhci1: Hardware doesn't specify
> : > timeout clock frequency.
> : > Nov 6 16:32:20 NB0117232 kernel: sdhci1: Hardware doesn't report any
> : > support voltages.
> :
> : Looks like it is not enough compatible, or even not compatible.
>
> Chances are good that you need to the workaround to turn on these
> things.



Here is some datasheet I have found for R5C832, but it looks not too
detailed to say something for sure:
http://www.aeneas.com.cn/PDF/Ricoh/2...%5B1%5D.00.pdf

At least it says that it's MMC interface is single-bit, while standard
SD host controller has 4 bit's bus.

--
Alexander Motin
_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/lis...reebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"