This is a discussion on Re: infinite loop when copying to ext2fs - FreeBSD ; Jakub Siroky wrote: > I've just confirmed the same situation on 6.2-RELEASE amd64/GENERIC. I > did not noticed it before because I started using ext2fs extensively > some months ago. > > Regards, > Jakub > > On Sat, 19 ...
Jakub Siroky wrote:
> I've just confirmed the same situation on 6.2-RELEASE amd64/GENERIC. I
> did not noticed it before because I started using ext2fs extensively
> some months ago.
> On Sat, 19 Jan 2008 16:44:34 +0100
> Kris Kennaway
>> Kris Kennaway wrote:
>>> Jakub Siroky wrote:
>>>> I have two large ext2fs partitions (368 and 313GB) to hold data
>>>> shared between several OSes. While there were no problems on
>>>> 6-STABLE branch I was quite disappointed after upgrade to
>>>> 7-STABLE. Whenever I copy/write to ext2fs partition the system
>>>> freezes totally without crashdump. So I set debugging settings to
>>>> kernel config (DEBUG,WITNESS,..) and in console I reproduced error
>>>> situation ending with full screen of unstoppable running text with
>>>> lot of memory addresses and a few recognisable words: 'new block
>>>> bit set for ext already' - again with no crashdump. Then I have
>>>> formatted 1GB partition with ext2fs and the problem on this small
>>>> partition appears only sometimes.
>>> OK, I am able to reproduce this.
>> Is anyone able to look at this? I could not spot a candidate change
>> that has not been merged to 6.x.
Sounds like it may have been broken by the change to ext2_bitops.h by
cracauer. Can you confirm whether backing out 22.214.171.124 fixes it?
email@example.com mailing list
To unsubscribe, send any mail to "firstname.lastname@example.org"