OK, understand all you say re DVDs & late & original etc :-)

> > BTW
> > Anyone know if Dimitry should change his mailer sender config &/
> > or If I need a config tweak to my EXmh-2.7.2 On FreeBSD-6.2-RELEASE,
> > to avoid the mess above on clicking "Reply-All". (No I'm not looking
> > for "Abandon EXMH, use my better XYZ", but if there's a
> > config tweak to EXMH ? )

> Did not get this, do I do anything wrong?

I don't know what's wrong which end. I've seen a similar problem
before, & then was advised approx. "Sylpheed works, so switch", but
mail readers are like favourite flavours of beer, each prefers his
own, so I was trying to pre-empt "Switch" by asking what's wrong
where & if I can reconfig EXMH to allow for it.

I couldn't just click & reply on your first mail, but I can on your
2nd post. Both appeared in EXMH reader as Ascii legible english
text, followed by Russian font signature lines. So no loss in
appearance, just 2nd easier to reply to. Would be nice if someone
knew what to tweak in EXMH to cope with 1st post.
Somethings in Preferences MIME I assume, but can't see it.

Your 1st posting had:
MIME-Version: 1.0
Content-Type: multipart/mixed; boundary="===============1475038008=="
- --===============1475038008==
Content-Type: text/plain;
Content-Transfer-Encoding: base64
Content-Disposition: inline

R29vZCBkYXksIGV2ZXJ5Ym9keS4KQXMgZmFyIGFzIEkga25vdy B0aGVyZSB3aWxsIGJlIG5vdyAz
The FreeBSD.org mailman software presumably prepended
- --===============1475038008==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
Before, & moved
- --===============1475038008==--
After the list footer.
(Which BTW is more than stock majordomo does (eg on berklix.org lists)).

Your 2nd posting had a simpler:
MIME-Version: 1.0
Content-Type: text/plain;
Content-Disposition: inline

Julian Stacey. BSD Unix Linux Net Consultant, Munich. http://berklix.com
freebsd-current@freebsd.org mailing list
To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"