I'm attempting to create an Active-Active failover configuration on a pair of ASA 5550s.

Problem is, when I try clustering them up, I see the unconfigured secondary come up and take over the cluster, replacing the ruleset on the primary with the basic clustering setup config of the secondary

Basic config is 10.x.y.z /28 as internal, 10.x.y.a/240 as external, with the State failovers on /24 and LAN Failovers as /24

Failovers are cabled with crossovers. and the int and ext addresses as on the switch.

Any suggestions ???? Any idea what I'm doing wrong ??


firewall-wizards mailing list