Hello, I was wondering if someone could point me in the right
direction. I have come off a long run of managing Cyberguard
firewalls and am now in the Checkpoint realm, so forgive my ignorance.
I am having an issue with secure client. I have several SoHo users
whose default routers place them on a network. These users
cannot connect to the gateway. Dumps on the checkpoint fw gateway
show no incoming packets and a dump on the client show udp 500 leaving
the client, which leads me to the router/firewall @ the SoHo. Router
makes vary, anywhere from 2wire to netgear, the result is the same. I
initially thought it had something to do with the routing topology
since our topology pushes a static route for a 172 network, but I had
the SoHo router changed to a 10 network that is statically routed in
the topology and that worked fine. At this point I am at a loss. Any
suggestions would be appreciated.

Thank you,
firewall-wizards mailing list