RE: [fw-wiz] Switch Redundancy for my firewall cluster
To answer your specific questions...
A1. See below.
| sw1 | <-backplane-> | sw2 |
| fw1 | <---sync----> | fw2 |
| sw4 | <-backplane-> | sw4 |
Or if you don't want to backplane the two pairs of switches, you can cross
them over with 802.1q trunk ports. Assign a VLAN for every subnet the
firewall has an interface on, and trunk that VLAN to the other switch in the
pair (in the diagram above, sw1 and sw2 would trunk VLANs to each other,
same as sw3 and sw4).
A3. 802.1q VLAN tagging and trunking, that's how. (see above)
A4. No. Your firewall cluster can (if you buy the right licenses) do the
load balancing for you, if you require it. Otherwise, you'll end up with a
fail-over configuration. Doing L4+ load-balancing with the switches will
not get you load balancing through the firewall, only on either side of it.
The firewall would still be a choke point since the same cluster member
would be handling all traffic sent to the cluster addresses.
[mailto:firstname.lastname@example.org] On Behalf Of Nick
Sent: Sunday, May 01, 2005 8:03 PM
Subject: [fw-wiz] Switch Redundancy for my firewall cluster
Dear (Cisco) guru,
Want to elimate every single point of failure for my network topology.
Planning to have firewall cluster and switch redundancy
* Check Point - Unlimited x2 (SecurePlatform)
* Cisco 29XX switch x 4 (two upstream & two
1. How the network topology looks like?
2. Do we need a delegate/physical connection from each firewall member/node
to two upstream switches and two downstream switches?
3. If so, how is it possible? Because Check Point is running as router mode
and it means each physical ports will carry different segments and we have
to set up two different segments for each ports connecting to two upstream
switches and so do for the downstream switches in order to do the "Cross"
4. Do we need L4-7 Switch in order to do so?
as per the network diagram from Cisco
Any ideas will be appreciated.
firewall-wizards mailing list