How to add a new IDE controller chip driver
I have a custom FPGA that implements a simple PATA interface on a
PPC440GX. For PIO accesses to the disk, the FPGA simple acts as a "bus
translator" converting 440GX External Bus cycles to the appropriate IDE
bus cycles. For READ DMA EXT and WRITE DMA EXT commands, the FPGA also
provides DMA to UDMA conversion so that the 440GX's internal DMA engine
can tranfer the data to/from the disk via the FPGA.
I'm looking through the Linux sources, specifically the drivers/ide
directory, and it's not jumping out at me as to how to tape in my FPGA
controller so that Linux can use it. I'm especially confused about how
I'm going to get the Linux IDE subsystem to use the 440GX's built-in
DMA for UDMA transfers since I suspect most standard ATA controllers
have their own bus-mastering DMA capabilities. There seems to be a
hardware interface context that one assigns chip-specific
implementation functions to but I can't find when or where the
assignment is done.
Can anyone suggest how I might go about doing this? Are there books
specific to writing IDE drivers for Linux? Or do I simply need to spend
many hours poking at the code until I figure out how to hack my custom
controller into the correct form?