openBSD 3.7 and Dlink 650+ wless cardbus - BSD

This is a discussion on openBSD 3.7 and Dlink 650+ wless cardbus - BSD ; at install i used the Dynalink Cardbus, what was config with no trub. now, i trie to install my Dlink 650+ wlan cardbus. but i dont know how to do so. if i do ifconfig fxp0 inet 192.168.0.241 netmask 255.255.255.0 ...

+ Reply to Thread
Results 1 to 2 of 2

Thread: openBSD 3.7 and Dlink 650+ wless cardbus

  1. openBSD 3.7 and Dlink 650+ wless cardbus

    at install i used the Dynalink Cardbus, what was config with no trub.

    now, i trie to install my Dlink 650+ wlan cardbus.
    but i dont know how to do so.
    if i do ifconfig fxp0 inet 192.168.0.241 netmask 255.255.255.0 is says device
    not configured.

    help !


  2. Re: openBSD 3.7 and Dlink 650+ wless cardbus

    abuse@microsoft.com writes:

    > at install i used the Dynalink Cardbus, what was config with no trub.
    >
    > now, i trie to install my Dlink 650+ wlan cardbus.


    You are talking about two different cards here?

    > but i dont know how to do so.
    > if i do ifconfig fxp0 inet 192.168.0.241 netmask 255.255.255.0 is says device
    > not configured.


    the fxp driver is almost certainly wrong for a D-link card. Check your
    dmesg output for wi or ath devices

    --
    Peter N. M. Hansteen, member of the first RFC 1149 implementation team
    http://www.blug.linux.no/rfc1149/ http://www.datadok.no/ http://www.nuug.no/
    "First, we kill all the spammers" The Usenet Bard, "Twice-forwarded tales"

+ Reply to Thread