If i write ">>>ecu", the arc firmware is loaded and initialize devices and
return this message :
"Error : Device error, press any key to continue"...
but it is not indicated the device where there is error ...
but if i run arc with ">>>arc" it will loaded without error ...

ad...

ps: for install tru64 i may boot on SRM or ARC firmware ?? it's SRM no ?


"Richard Tomkins" a écrit dans le message de news:
41984023$1_5@127.0.0.1...
> Run the ECU to set up all the hardware on the system for Tru64 UNIX.
>
> Contrary to what others will tell you, there is no substitute for not
doing
> this. It must be done to ensure that the system architecture has been set
> properly.
>
> rtt
>
>
> "rainer lörwald" wrote in message
> news:41968F2F.DAC10C13@gmx.de...
> > I agree to "must be s DEC approved..". CD-Drive should be identified as
> > an RRD42 or 43, otherwise it won´t boot. I tried with other SCSI CD-Rom
> > drives without success.
> > I always used "set boot_osflags s" from the console to start
> > installation from CD, as this will run in a single user environment.
> >
> > Hope this helps
> > Rainer
> >
> >
> > ad schrieb:
> > >
> > > Hi all,
> > >
> > > I'm the owner of a alphaserver 1000A 4/266 and I try to install
tru64...
> > > But i have a problem
> > >
> > > On the SRM prompt :
> > >
> > > >>>boot dka0
> > >
> > > return :
> > >
> > > "device dka is invalid"
> > >
> > > >>>show device
> > >
> > > return a dka400 device but
> > >
> > > >>>boot dka400
> > >
> > > return :
> > >
> > > (boot dka400.4.0.2000.0 -flags 0)
> > > failed to open dka400.4.0.2000.0
> > >
> > > May i have a CD drives problem ...
> > >
> > > How can i see if my CD drive is ready or if it is dead ?
> > >
> > > Thx u and sorry for my bad frenchy language ...
> >
>
>
>
>
> ----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet
News==----
> http://www.newsfeeds.com The #1 Newsgroup Service in the World! >100,000
Newsgroups
> ---= East/West-Coast Server Farms - Total Privacy via Encryption =---